Last night I installed the HealTech iQSE-1, some new spark plugs and the grips. One of the throttle cable ends snapped when I was tightening it (hand tight and 1/4 turn, surprised it couldn't handle that considering the other cable was tightened the same with no issues), so the throttle is on hold till I hear back from the dealer and/or manufacturer. The new spark plugs are gapped at .026" (manual says .026-.028), the old plugs are over .030 yet don't look too bad.
The iQSE-1 was pretty easy to install and very easy to get setup. I started at 65ms kill time and it seemed a little slow, so I changed it to 60ms after getting to work this morning. The sensor is very small and hardly noticeable on the bike, the controller is just stashed under the seat for now till I decide on a permanent location. For $320 it's well worth it and barely noticeable.
I talked to the guys at Robby Moto and they're sending me a new set of cables no charge, should have them in a couple weeks. Great customer service.